69J1D11
4-8
1
2
3
4
5
6
7
8
9
WARNING
Always reduce the fuel pressure in the
high-pressure fuel line before servicing
the line or the vapor separator. If the fuel
pressure is not released, pressurized fuel
may spray out.
3. Remove the cap
3
, and then press in
the valve
b
using a thin screwdriver
2
.
4. Place a container under the vapor sepa-
rator, and then drain the fuel from the
separator by removing the drain screw
4
.
WARNING
Reduce the fuel pressure before removing
the vapor separator drain screw, or pres-
surized fuel will spray out and may result
in serious injury.
Checking the vapor separator
1. Check the needle valve for bends or
wear. Replace if necessary.
2. Check the float for deterioration. Replace
if necessary.
3. Check the filter for dirt or residue. Clean
if necessary.
S69J4075
Vapor separator
To Next Page
Loading...
Need help?
General
