Yamaha V50 - Page 37

KAA
EE eee eee ad i
Settings for 5: Delay L/R, 6: Stereo Echo
Parameter
=
Settings
Comment
Leh Dly 0 ms--300 ms
Specify the delay time for the left
channel. As this setting is in-
creased, there will be a longer
wait until the first delayed sound
from the left channel.
Rch Dly
0 ms-300 ms
Specify the detay time for the
right channel. As this setting is
increased, there wil! be a longer
wait until the first delayed sound
from the right channel.
FB Gain
0%-99%
Specify the amount of feedback.
For a setting of 0%, there will be
only a single delayed sound.
Settings for 7:Distortion Rev.
Parameter Settings Comment
Time
Dist.
Reverb
0.3 sec-18.3 sec
0%~ 100%
<t
Specify the time it takes for the
reverb to decay. Long settings
(long times)
slower decay.
reverb cause a
Specify the amount of distortion.
Higher settings will cause more
distortion.
0%: 100% Specify the amount of reverb.
This determines the balance of
reverb and distortion.
Parameter Settings
Settings for 8: Distortion Echo, 15: Dist. & Delay
es TAE AR
Comment
Time 0 ms-300 ms Specify the time until the first
delayed sound. As this setting
is increased, there will be a longer
wait before the delayed sound
appears.
FB Gain 0%-99% Specify the amount of feedback.
For higher settings, there will be
more delay repeats.
Dist. 0%-100%
Specify the amount of distortion.
Higher settings will cause more
distortion.
Settings for 9: Gate Reverb, 10: Reverse Gate, 11: Early Ref
1
Parameter Settings Comment
Size 0.5-3.2 Specity the size of a hypothetical
room. Larger settings will cause
a more spacious effect.
LPF 1.25 KHz Specify the low pass filter set-
12.0 KHz, thru tings.
specified setting will be removed.
When “thru” is selected, this filter
will not be used.
Frequencies above the
Delay ie ms—50 ms
Specify the time until the effect
begins. As this setting
creased, there will be a longer
wait before the delayed sound
appears.
is in-
Settings for 12: Tone Control
Low frequency control (shelving
band pass filter at 800Hz). Pos-
itive settings boost, and negative
Middle frequency control (pres-
ence band pass filter at 1260Hz).
Positive settings boost, and ne-
Parameter Settings Comment
Low -12dB—+12dB
settings cut.
Middie —12dB—+12dB
gative settings cut.
High -12dB--+12dB
L
Settings for 13: Delay & Rev
High frequency control (shelving
band pass filter at 3KHz). Positive
settings boost, and negative
settings cut.
erb
Parameter Settings Comment
RevTime | 0.3 sec.—10.0 sec Specify the time it takes for the
reverb to decay. Long settings
(long reverb times)
slower decay.
cause a
Delay 0 ms.—152 ms Specify the delay time. As this
setting is increased, there will
be a longer wait before the de-
tayed sound appears.
FB Gain | 0%.-99% Specify the amount of delay
feedback. As this setting is in-
creased, there will be more delay
repeats.
Performance Edit 33