Yamaha XVS250 2001 - Installing the Rear Wheel; Adjusting the Rear Wheel Static Balance

4-19
REAR WHEEL AND REAR BRAKE
CHAS
104 Nm (10.4 mkg)
WARNING
NOTE:
EAS00571
INSTALLING THE REAR WHEEL
1. Lubricate:
 wheel axle
 wheel bearings
 oil seal lips
Recommended lubricant
Lithium soap base grease
2. Adjust:
 drive chain slack
Drive chain slack
30  40 mm
Refer to “ADJUSTING THE DRIVE CHAIN
SLACK” in chapter 3.
3. Tighten:
 wheel axle nut
Make sure that the brake hose is routed
properly.
EAS00575
ADJUSTING THE REAR WHEEL STATIC
BALANCE
 After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
 Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
1. Adjust:
 rear wheel static balance
Refer to “FRONT WHEEL”.