1-5
SPECIAL TOOLS
GEN
INFO
EB102001
SPECIAL TOOLS
The following special tools are necessary for complete and accurate tune-up and assembly. Use only
the appropriate special tools; this will help prevent damage caused by the use of inappropriate tools or
improvised techniques. Special tools may differ by shape and part number from country to country. In
such a case, two types are provided.
When placing an order, refer to the list provided below to avoid any mistakes.
Tool No.
Tool name / How to use Illustration
Bolt
90890-01085
Weight
90890-01084
Slide hammer bolt/Weight
These tools are used to remove the rocker
arm shaft.
Valve adjusting
tool
90890-01311
Tappet adjusting tool
This tool is used to adjust the valve
CLEARANCE.
T-handle
90890-01326
Damper rod
holder
90890-01365
T-handle/Damper rod holder (22 mm)
These tools are needed to loosen and
tighten the damper rod holding bolt.
90890-01304
Piston pin puller set
This tool is used to remove the piston pin.
90890-01312
Fuel level gauge
This gauge is used to measure the fuel level in
the float chamber.
Flywheel puller
90890-01362
Flywheel puller
These tools are needed to remove the rotor.
90890-01403
Ring nut wrench
This tool is used to loosen and tighten the
steering stem ring nut.
Weight
90890-01367
Adapter
90890-01369
Front fork seal driver weight/
Adapter (33 mm)
These tools are needed when installing the
slide metal, oil seal and dust seal into the fork.
To Next Page