3-11
ADJUSTING THE THROTTLE CABLE FREE PLAY
CHK
ADJ
NOTE:
a
b
NOTE:
a
b
EAS00058
ADJUSTING THE THROTTLE CABLE FREE
PLAY
Prior to adjusting the throttle cable free play, the
engine idling speed should be adjusted.
1. Check:
S throttle cable free play
a
Out of specification Adjust.
Throttle cable free play (at the
flange of the throttle grip)
3 X 5 mm
2. Remove:
S fuel tank
3. Adjust:
S throttle cable free play
Carburetor side
a. Loosen the locknut
1
.
b. Turn the adjusting nut
2
in direction
a
or
b
until the specified throttle cable free play is
obtained.
Direction
Throttle cable free play
is increased.
Direction
Throttle cable free play
is decreased.
c. Tighten the locknuts
1
.
If the specified throttle cable free play cannot be
obtained on the carburetor side of the cable, use
the adjusting nut on the handlebar side.
Handlebar side
a. Loosen the locknut
1
.
b. Turn the adjusting nut
2
in direction
a
or
b
until the specified throttle cable free play is
obtained.
Direction
Throttle cable free play
is increased.
Direction
Throttle cable free play
is decreased.
c. Tighten the locknut
1
.
To Next Page