1.5 Replace the Drive
68 YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting
■ Connect the Control Circuit Terminal Block
1. To put a wired control circuit terminal block in the drive, align it with the guides and move it straight up.
A - Guides
Figure 1.94 Put the Terminal Block into the Connector
2. Use M3 screws to safety the terminal block.
Tighten the screws to a correct tightening torque:
• M3 screws: 0.5 N∙m to 0.6 N∙m (4.4 lbf∙in to 5.3 lbf∙in)
Figure 1.95 Safety the Terminal Block
3. Install the front cover and the keypad to their initial positions.
4. Check o2-04 [Drive Model (KVA) Selection].
Note:
• When you save parameter information in a keypad that you installed before you replaced the terminal block, make sure that you use that
keypad to restore the parameter data.
• To reset the performance life monitors for the components, set o4-01 to o4-13 [Maintenance Period].
To Next Page
Loading...
