Periodic Inspection and Maintenance
1
1.5 Replace the Drive
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting 67
5. Check the terminal sign that you wired and use a nipper as shown in Figure 1.92 to clip the specified cutaway
section of the wiring cover.
Note:
6-Phase/12-pulse drives (models: Txxx) do not have the wiring covers.
A - Cutaway sections B - Clip here with nippers
Figure 1.92 Clip the Cutaway Section of the Wiring Cover
Note:
• Different drive models have different wiring cover shapes.
• Only clip the section of the wiring cover that applies to the wired terminal. If you clip areas that do not apply to wired terminals,
the protective enclosure will not keep its IP20 protective level.
• Be careful when clipping the cutaway section of the wiring cover, as the section may fly out in unpredictable directions.
• Make sure that the clipped section does not cause damage to the wires.
• If you use wires that are not specified by Yaskawa, the protective enclosure could lose its IP20 protective level, although the
wiring cover is correct. Contact Yaskawa or your nearest sales representative for more information.
6. Put the wiring cover in its initial position. Put the cables through the holes that you cut out of the wiring cover.
Note:
6-Phase/12-pulse drives (models: Txxx) do not have the wiring covers.
Figure 1.93 Reattach the Wiring Cover
To Next Page
Loading...
