YASKAWA iQpump Micro CIMR-PW Series

Modified Consts
Appl (005)
Std (003)
PRG RDY
Modified Consts
- MODE - PRG RDY
>> Appl (005) <<
Std (003)
Modified Consts
- MODE - PRG RDY
--changes after
Information about
the selection is
scrolled
Double arrows
indicate selection
Modified Consts
- MODE - PRG RDY
(idle)
Output Level Sel
-VERIFY- PRG
b5-09= 1 *1*
Inverse Acting
Parameter changed after
Initializing using A1-03
Ref Source 1
-VERIFY- PRG
b1-01= 1 *1*
Analog Input
Monitor Menu
U1-01=
U1-02=
U1-03=
14.00 Hz
0.00Hz
0.00A
- MODE - DRV RDY
FFWWDD
Pump Quick Setup
- MODE - PRG
FFWWDD
Main Menu
F2
F2
F2
Modified Type Selection
Parameter View
Parameter changed from
factory default setting
>> Appl (005) <<
Std (003)
Appl (005)
>> Std (003) <<
Std is now
selected
Home
Home
DATA
Home
Home
DATA
Home
DATA
Home
DATA
Home
Home
-MODE-
Steps to change parameter C1-02, Deceleration Time, from 14.0 to 24.0 seconds:
Step Display/Result
1. Turn on the power to the drive. The initial display appears.
- MODE -
U5-99= 0.0PSI
U1-02= 0.00Hz
U1-91= 0.0PSI
DRV
Auto Setpoint
Rdy
<-MONITOR->
LSEQ
LREF
2.
Press
or until the display shows the top of the Modified Constants Menu.
- MODE - PRG RDY
Modified Consts
Home
FWD
Appl (005)
Std (003)
DATA
3.
Press
then to select standard (Std) parameters that have been edited from their
original default settings.
- MODE - PRG
Modified Consts
Home
FWD
Appl (005)
>> Std (003) <<
DATA
4.
Press to enter the list of standard parameters that have been edited from their original
default settings.
If parameters other than C1-02 have been changed, use
or to scroll until C1-02
appears.
C1-02 = 14.0sec
(0.0~6000.0)
“10.0sec”
FWD
- VERIFY - PRG
Accel Time 1
Rdy
Home
5.
Press
to access the setting value. Left digit flashes.
FWD
C1-01=0014.0sec
(0.0~6000.0)
“10.0sec”
- VERIFY - PRG
Accel Time 1
Rdy
Home
4.6 Using the Optional HOA Keypad
84
YASKAWA TOEP YAIQPM 03B YASKAWA AC Drive - iQpump Micro User Manual