6-3
167109-1CD
HW1482308
6 Allowable Load for Wrist Axis and Wrist Flange
6.2 Wrist Flange
MS165
6.2 Wrist Flange
The wrist flange dimensions are shown in fig. 6-2 “Wrist Flange” . In
order to see the alignment mark, it is recommended that the attachment
be mounted inside the fitting. Fitting depth of inside and outside must be 8
mm or less.
Fig. 6-2: Wrist Flange
63 dia.
+0.030
0
160 dia.
0
-0.025
+0.015
0
10 dia.
(2 holes) (depth: 8 mm)
+0.015
0
9 dia.
(2 holes) (depth: 8 mm)
M10 (6 holes) (depth: 14mm)
M10 (6 holes) (depth: 14mm)
NOTE
Wash off anti-corrosive paint (yellow) on the wrist flange
surface with thinner or light oil before mounting the tools.
To Next Page
Loading...
