1. Select “Encoder Setting > Motor parameter scale write”.
2. When you are sure that the settings match the connected motor, confirm the text in
the displayed dialogue box with OK. Click on Cancel to return to the main window
without writing motor parameters to the scale.
ð
After clicking OK, the SERVOPACK starts reading the parameter information
from the scale.
Sigma-5 and Sigma-7 Series SERVOPACKs
Set-up Procedure
Feedback Option Module Set-up
| | Feedback Option Module Type 3 - Manual version C - Revision 0 | en | 64
To Next Page
Loading...
