YASKAWA SGDV-OFB03A - Page 68

1. Select “Basic Functions > Edit Parameters”.
2. Set parameter Pn00B.3 (Feedback Option Module Usage) to one of the following
two values depending on the use:
n 0 (Uses for Fully-Closed Loop Control).
n 1 (Uses for Semi- Closed Loop Control)
(3) Select Fully-closed
Operation or Semi-closed
Operation
Sigma-5 and Sigma-7 Series SERVOPACKs
Set-up Procedure
Feedback Option Module Set-up
| | Feedback Option Module Type 3 - Manual version C - Revision 0 | en | 68