YASKAWA SGMAH - Page 357

Sigma II User’s Manual Chapter 8: Ratings and Characteristics
8 - 31
*1
Allowable regenerative energy is the value with an AC input power supply voltage of 200V
rms
.
This may vary with power supply fluctuation.
*2
The regenerative frequency for motor combinations with the SGDH-60AE/-75AE assume that
the JUSP-RA04 or JUSP-RA05 Regenerative Resistor Unit is used. For information on
regenerative resistor units, refer to 5.6.1 External Regenerative Resistors or to 5.2.5 Regenerative
Resistor Units in this manual.
Voltage Single-phase 200V Three-phase 200V
Servo Amplifier Model
SGDH-
A3AE A5AE 01AE 02AE 04AE 08AE-S 15AE-S — 08AE — 15AE
SGMPH Series
Applicable
Servomotor
Model
SGMPH-
— — 01A 02A 04A 08A 15A — 08A — 15A
Capacity
(kW)
— — 0.1 0.2 0.4 0.75 1.5 — 0.75 — 1.5
Motor Speed
(rpm)
Rated 3000/maximum 5000
Applicable Encoder
Standard: 13-bit incremental encoder
Continuous Output
Current
A
rms
— — 0.89 2.0 2.6 4.1 7.5 — 4.1 — 7.5
Maximum Output Current
A
rms
— — 2.8 6.0 8.0 13.9 23.0 — 13.9 — 23.0
Allowable Regenerative
Energy
*
(Joules)
— 37.1 — —
Allowable Regenerative
Frequency
**
(times/min)
——29—17
Voltage Three-phase 200V
Servo Amplifier Model
SGDH-
05AE 08AE 10AE 15AE 20AE 30AE. 50AE 60AE 75AE 1AAE 1EAE
SGMGH Series
Applicable
Servomotor
Model
SGMGH-
05AA — 09AA 13AA 20AA 30AA 44AA 55AA 75AA 1AAA 1EAA
Capacity
(kW)
0.45 — 0.85 1.3 1.8 2.9 4.4 5.5 7.5 11 15
Motor
Speed
(rpm)
Rated 1500/maximum 3000
Applicable
Encoder
Standard: 17-bit incremental encoder
Continuous
Output Current
A
rms
3.8 — 7.1 10.7 16.7 23.8 32.8 42.1 54.7 58.6 78.0
Maximum
Output Current
A
rms
11—1728425684110130140170
Allowable
Regenerative
Frequency
*2
(Times/min)
34—131012 8 1126** 36**