10 Appendix
10.1.1 List of Parameters
10-4
Parameter
No.
Name Setting Range Units
Factory
Setting
Setting
Validation
Reference
Section
Pn001 Function Selection Application Switch 1
−−0000 After
restart
−
Pn002 Function Selection Application Switch 2
−−0000 After
restart
−
Servo OFF or Alarm Stop Mode
0
Stops motor by applying dynamic brake (DB).
1
Stops motor by applying dynamic brake (DB) and then releases DB.
2
Makes motor coast to stop without using dynamic brake (DB).
Overtravel Stop Mode
0
Same setting as Pn001.0 (Stops motor by applying DB or by coasting).
AC/DC Power Input Selection
0
Not applicable to DC power input: Input AC power supply through L1, L2, and (L3)
terminals.
1
Applicable to DC power input: Input DC power supply between B1/ ⊕ and , or input DC
power supply between B1/ ⊕ and 1.
Reserved (Do not change)
3rd 2nd 1st 0
digit digit digit digit
n. FFFF
Reserved (Do not change)
Reserved (Do not change)
Absolute Encoder Usage
0
Uses absolute encoder as an absolute encoder.
1
Uses absolute encoder as an incremental encoder.
Reserved (Do not change)
3rd 2nd 1st 0
digit digit digit digit
n. FFFF
SIEPS80000025.book 4 ページ ２００４年１０月２５日 月曜日 午前１１時５７分
To Next Page
Loading...
