YASKAWA VIPA System MICRO M13-CCF0000 - Page 221

Event ID Description
0xE828 Internal message
0xE829 Internal message
0xE82A CMD - Auto command: CPUTYPE_318 recognized and successfully executed
ZInfo3 : Error code
0: No Error
1: Command not possible
2: Error on storing the attribute
0xE82B CMD - Auto command: CPUTYPE_ORIGINAL recognized and successfully executed
ZInfo3 : Error code
0: No Error
1: Command not possible
2: Error on storing the attribute
0xE8FB CMD - Auto command: Error: Initialization of the Ethernet PG/OP channel by means of SET_NETWORK is
faulty
0xE8FC CMD - Auto command: Error: Some IP parameters missing in SET_NETWORK
0xE8FE CMD - Auto command: Error: CMD_START missing
0xE8FF CMD - Auto command: Error: Error while reading CMD file (memory card error)
0xE901 Check sum error
ZInfo1 : Not relevant to the user
ZInfo2 : Not relevant to the user
DatID : Not relevant to the user
0xE902 Internal error - Please contact the hotline!
0xEA00 Internal error - Please contact the hotline!
0xEA01 Internal error - Please contact the hotline!
0xEA02 SBUS: Internal error (internal plugged sub module not recognized)
ZInfo1 : Slot
ZInfo2 : Type ID set
ZInfo3 : Type ID
PK : Not relevant to the user
DatID : Not relevant to the user
0xEA03 SBUS: Communication error between CPU and IO controller
ZInfo1 : Slot
ZInfo2 : Status
0: OK
1: Error
2: Empty
3: Busy
4: Timeout
5: Internal blocking
VIPA System MICRO
System specific event IDs
HB400 | CPU | M13-CCF0000 | en | 16-47 221