YASKAWA VIPA System MICRO M13-CCF0000 - Page 222

Event ID Description
6: Too many frames
7: Not connected
8: Unknown
PK : Not relevant to the user
DatID : Not relevant to the user
OB : Operation mode
0: Configuration in operation mode RUN
1: STOP (update)
2: STOP (overall reset)
3: STOP (own initialization)
4: STOP (internal)
5: Start-up (cold start)
6: Start-up (cold restart/warm start)
7: Start-up (restart)
8: RUN
9: RUN (redundant operation)
10: HALT
11: COUPLING
12: UPDATING
13: DEFECTIVE
14: Troubleshooting
15: Without power
0xFD: Process image enabled in STOP
0xFE: Watchdog
0xFF: Not set
0xEA04 SBUS: Multiple configuration of a periphery address
ZInfo1 : Periphery address
ZInfo2 : Slot
ZInfo3 : Data width
0xEA05 Internal error - Please contact the hotline!
0xEA07 Internal error - Please contact the hotline!
0xEA08 SBUS: Parametrized input data width unequal to plugged input data width
ZInfo1 : Parametrized input data width
ZInfo2 : Slot
ZInfo3 : Input data width of the plugged module
0xEA09 SBUS: Parametrized output data width unequal to plugged output data width
ZInfo1 : Parametrized output data width
ZInfo2 : Slot
VIPA System MICRO
System specific event IDs
HB400 | CPU | M13-CCF0000 | en | 16-47 222