4. WIRING
.. Wiring Instructions
(1) Connect the power supply wiring to terminals LI(R), N/L2(S) and L3(T)
on the main circuit input side (top of the inverter).
Inverter Power Supply Specifications
200V3-phase Inpul 1200VSingle-/3-phaseInpel PowerSupplySpecification 100VSingle-phaseIflput
PowerSupply PrOduct PowerSupplySpecificatiol
SpecificationProductICIMRoXC23E2_SZ3 Product
' CIMFI-XC--2_ ' CIMR-XC_a--_
Connectto L1(R). 3-phase input :Connectto LI(R), N/L2(S),L3(T) Connectto LI(R), N/L2.(5)
N/L2(S).L3(1) Single-phaseinput :Connectto LI(R), N/L2(S)
(2) Connect the motor wiring to terminals U, V and W on the main circuit
output side (bottom of the inverter).
(3) Separate the inverter wiring from the motor wiring - 328ft (100m) max.
If the wiring distance between inverter and motor is long, reduce the
inverter carrier frequency. For details, refer to "Reducing motor noise
or leakage current (n37)" on page 42.
(4) Control wiring must be less than 164fl(5om) in length and separate from
the power wiring. Use twisted-pair shielded wire when inputting the
frequency signal externally.
" Wire and Terminal Screw Sizes
Wire
Circuit Model Terminal Symbol 3o'e_ Size
mEn2 _WG Type
CIMR-XC_7 :_,S, T, 81, [32,
_ZIZIT_I 0.75to 2 18to 14 600Vvinyl-
Vlain (Ja_qnuse) J, V, W, (_ M3,5 sheathed m
rtOOVsing_phase:_ qgOVsing_-pt_ase wire or
Circuit CIMR-X_ZI _1, N/L2.,L3, B1. B2 } equivalentE/ISl-[I 1.25Io2 16to14
(F_uropeuse J,V,W,
_F.SR, $1. $2, $3, twisted :0,5 to 075 Twisted: 20 to t8
3C, FS, FR, FC, AM, _hielded
._,ontrolCommon 5ingle: O.Sto t25 Single :201o 16
2ircuit to all a.C, PA, PC -- wire or
models Fwisted:05 to t25 Twisted: 20to 16 equivalent
VIA, MB, MC
3ingle:05 to 125 Single:20 to 16
16
To Next Page
Loading...
Need help?
General