• Wiring the Control Circuit
Terminal functions described below are based on factory settings.
/
0 0 0.0 0 0 0
LT#T P,OTO_OU_LE,
CONTACT OUTPUT
,OUTPUTOURING IOLOLOIoIoIoIoI
I_ I'_ I& I=_I'=sIN I'=cI
refer ..... II _ _ I[_IT I_, I
For details, to "Standard PRWAR_-T
• . u u/,mEn,/FAOtT|I FREQUENCYSETTING
Wiring" on page 68. RUN/STOPI_JREstr_I I VOLUMERESISTOR
Wirino the control circuit terminals
t Screwdriver blade width
//0.098io._n_x
0.016 in. _mm)
(0.4 ram)
In,sen the wire into the lower part of the terminal block and connect it tightly
with a screwdriver.
0.22in.
(5.5mm
"_-_- Wire sheath strip length must be 0.22in. (5.5mm).
Open the control circuit terminal cover and verify that the strip length is
0.22in. (5.5mm).
SCALE
TERMINAL BLOCK _/
L
18
To Next Page
Loading...
Need help?
General