Operator stop key selection (n61)* ]
Selects processing when STOP key is depressed during operation from
control circuit terminal.
Setting Description
0 STOP key effective when running from terminals.
When STOP key is depressed, the inverter stops according to the
setting of constant nO3. At this time, the digital operator displays
"SI-F'" alarm (blinking). This stop command is held in the inverter
until both forward and reverse run commands are open.
1 STOP key ineffectivewhen running from terminals.
*Not provided for softwareversion No. NSP600101 or before.
43
To Next Page
Loading...
