OPERATION
/_ WARNING
(Ref. page)
• Only turn ON the input power supply after replacing
the digital operator/blank cover (optional) and switching
the dip switch. Do not remove the digital operator or
the covers while current is flowing.
Failure to observe this warning can result in an electrical shock.. - ••20
• Never operate the digital operator or the switches
when your hand is wet.
Failure to observe this warning can result in an electrical shock.
• Never touch the terminals while current is flowing, even
during stopping.
Failure to observe this warning can result in an electrical shock.
• When the fault retry function is selected, stand clear of
the inverter or the load, since it may restart suddenly
after being stopped.
(Construct machine system, so as to assure safety for personnel,
even if the inverter should restart.) Failure to observe this
warning can result in personal injury.. ........................ 38
• When continuous operation after power recovery is
selected, stand clear of the inverter or the load, since
it may restart suddenly after being stopped.
(Construct machine system, so as to assure safety for personnel,
even if the inverter should restart.) Failure to observe this
warning can result in personal injury.- ........................ 34
• Since the digital operator stop button can be disabled
by a function setting, install a separate emergency
stop switch.
Failure to observe this warning can result in personal injury.
• If an alarm is reset with the operation signal ON, the inverter
restarts automatically. Only reset the alarm after verifying
that the operation signal is OFF.
Failure to observe this warning can result in personal injury.. ...... 20
6
To Next Page
Loading...
Need help?
General