EasyManuals Logo

Yealink SIP-T40G User Manual

Yealink SIP-T40G
253 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #197 background imageLoading...
Page #197 background image
Advanced Phone Features
185
2. You can do the following:
Press Hold to place the current multicast RTP session on hold.
The sender’s phone places the multicast RTP session on hold and receiver’s phone
releases the session.
To resume the held multicast RTP session, press Resume.
The multicast RTP session is re-established.
Press End Call (EndCall) to end the multicast RTP session.
Note
Sending RTP Stream via a Paging List Key
Procedure:
1. Press the paging list key when the phone is idle.
2. Select a desired paging group.
3. Press Paging to send RTP.
4. Your can do the following:
Press Hold to place the current multicast RTP session on hold.
The sender’s phone places the multicast RTP session on hold and receiver’s phone
releases the session.
To resume the held multicast RTP session, press Resume.
The multicast RTP session is re-established.
Press End Call (EndCall) to end the multicast RTP session.
Automatic Call Distribution (ACD)
ACD is often used in offices for customer service, such as call center. The ACD system handles
large volumes of incoming calls from callers who have no need to talk to a specific person but
who require assistance from any of multiple persons at the earliest opportunity. ACD on all IP
phone allows the ACD system to distribute large volumes of incoming calls to the registered
ACD users. To use this feature, you should configure an ACD key in advance. For more
information on ACD key icon indicators, refer to Status Indicators.
Note
ACD is not available by default. Check with your system administrator to find out if this feature is
available on your phone.
Multicast RTP is one way only from the sender to the multicast address(es) (receiver). For
outgoing RTP multicasts, all other existing calls on the phone will be placed on hold.
Downloaded from ManualsNet.com search engine

Table of Contents

Other manuals for Yealink SIP-T40G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink SIP-T40G and is the answer not in the manual?

Yealink SIP-T40G Specifications

General IconGeneral
MountingDesk/Wall
Handset typeWired handset
Product typeIP Phone
Product colorBlack
Wall mountableYes
Wi-FiNo
Security algorithmsAES, HTTPS, SSL/TLS
Networking standardsIEEE 802.3af
Ethernet LAN interface typeGigabit Ethernet
Supported network protocolsFTP, TFTP, HTTP, HTTPS
Voice codecsG.711, G.711a, G.711u, G.722, G.726, G.729ab
RJ-11 ports quantity1
Ethernet LAN (RJ-45) ports2
AC adapter input voltage100 - 240 V
AC adapter output current0.6 A
AC adapter output voltage5 V
Power consumption (typical)1.6 W
CertificationCE, FCC, ISO 9001
Operating temperature (T-T)-10 - 50 °C
Operating relative humidity (H-H)10 - 90 %
Volume controlDigital
Display diagonal2.3 \
Display resolution132 x 64 pixels
Lines quantity3 lines
Phonebook capacity1000 entries
Number of VoIP accounts3
Number of handles included1 pc(s)
Weight and Dimensions IconWeight and Dimensions
Depth175 mm
Width212 mm
Height54 mm

Related product manuals