Yealink T27G

Phone Customization
141
You can configure what contact information presents and how to display the contact information. If the
contact exists in the phone directory, the phone displays the saved contact name and number. If not, it
will use Calling Line Identification Presentation (CLIP) or Connected Line Identification Presentation (COLP)
to display the contact’s identity.
Topic
Call Display Configuration
Call Display Configuration
The following table lists the parameters you can use to configure call display.
Parameter
phone_setting.contact_photo_display.enable
<y0000000000xx>.cfg
Description
It configures whether to display contact avatar when it receives an incoming call, dials
an outgoing call or engages in a call.
Note: It is only applicable to T54S/T52S/T48S/T48G/T46S/T46G/T29G IP phones.
Permitted
Values
0-Never, do not display contact avatar no matter whether the contact avatar exists or
not
1-Always, display the customized contact avatar if it exists; display the built-in avatar if
the customized contact avatar does not exist
2-Adaptive, display the customized contact avatar if it exists; otherwise do not display
Default
1
Web UI
Settings->Call Display->Contact Photo Display Mode
Parameter
account.X.picture_info_enable
[1]
<MAC>.cfg
Description
It enables or disables the IP phone to download the picture from the URL contained in
the Call-Info or Caller-Image Header of Invite message.
Note: It is only applicable to T54S/T52S/T48S/T48G/T46S/T46G/T29G IP phones.
Permitted
Values
0-Disabled
1-Enabled