Call Features
283
Example
dialplan_replace_rule.url = http://192.168.10.25/DialPlan.xml
After provisioning, the rules defined in this file are added to the IP phone, and you can use the replace
rules on the phone.
Dial Plan Defined by Digit Map
Digit maps, described in RFC 3435, are defined by a single string or a list of strings. If a number entered
matches any string of a digit map, the call is automatically placed. If a number entered matches no string
- an impossible match - you can specify the phone’s behavior. You can specify the digit map timeout, the
period of time before the entered number is dialed out.
Topics
Basic Regular Expression Syntax for Digit Map
Digit Map for All Lines Configuration
Digit Map for a Specific Line Configuration
Basic Regular Expression Syntax for Digit Map
You need to know the following basic regular expression syntax when creating new dial plan:
The timer letter “T” indicates a timer expiry. If “T” is used alone (for
example, 123T), the default timeout value of 3 will be used. If “T” is
not used alone (for example, 123<Tx>, x can be a digit from 0 to 99),
a complete match occurs when waiting x seconds after inputting 123.
The “x” can be used as a placeholder for any digit from 0 to 9.
Example:
“12x” would match “121”, “122”, “123”, and so on.
The square bracket "[]" can be used as a placeholder for a single
character which matches any of a set of characters. Example:
"91[5-7]1234" would match “9151234”, “9161234”, “9171234”.
The dash “-” can be used to match a range of digits within the
brackets.
Example:
“[35-7]” would match the number “3”, “5”, ”6” or ”7”.
Note: The digits must be concrete, for example, [3-x] is invalid.
The dot “.” can be used as a placeholder or multiple placeholders,
including zero, of occurrences of the preceding construct.
Examples:
To Next Page
Loading...
Need help?
General
