Yealink T27G

Phone Network
49
RPC Method
Description
GetParameterAttributes
This method is used to read the attributes associated with
one or more CPE parameters.
SetParameterAttributes
This method is used to modify attributes associated with
one or more CPE parameters.
Reboot
This method causes the CPE to reboot.
Download
This method is used to cause the CPE to download a
specified file from the designated location.
File types supported by IP phones are:
 Firmware Image
 Configuration File
Upload
This method is used to cause the CPE to upload a
specified file to the designated location.
File types supported by IP phones are:
 Configuration File
 Log File
ScheduleInform
This method is used to request the CPE to schedule a
one-time Inform method call (separate from its periodic
Inform method calls) sometime in the future.
FactoryReset
This method resets the CPE to its factory default state.
TransferComplete
This method informs the ACS of the completion (either
successful or unsuccessful) of a file transfer initiated by an
earlier Download or Upload method call.
AddObject
This method is used to add a new instance of an object
defined on the CPE.
DeleteObject
This method is used to remove a particular instance of an
object.
TR069 Configuration
The following table lists the parameters you can use to configure TR069.
Parameter
static.managementserver.enable
<y0000000000xx>.cfg
Description
It enables or disables the TR069 feature.
Permitted
Values
0-Disabled
1-Enabled