Yealink T27G

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
298
For example:
dialplan.emergency.held.request_element.1.value = 001565B38ECB
dialplan.emergency.held.request_element.2.value =
6f2f2d50-c385-4b72-b84a-ce0ca3a77cb7
dialplan.emergency.held.request_element.3.value = 8611@pbx.yealink.com
Note: It works only if “dialplan.emergency.enable” is set to 1 (Enabled) and
“dialplan.emergency.asserted_id_source” is set to HELD.
Permitted
Values
String
Default
Blank
Parameter
account.X.reg_with_pani_header.enable
[3]
<MAC>.cfg
Description
It enables or disables the IP phone to carry the PANI header in the REGISTER request
message.
Permitted
Values
0-Disabled
1-Enabled
Default
0
Parameter
account.X.invite_with_pani_header.enable
[3]
<MAC>.cfg
Description
It enables or disables the IP phone to carry the PANI header in the INVITE request
message.
The PANI header format is:
P-Access-Network-Info:IEEE-802.3; eth-location=< MAC Address Of The Phone >;
local-time-zone=”0800”
Permitted
Values
0-Disabled
1-Enabled
Default
0
[1]
is from 1 to 3.
[2]
is from 1 to 255.
[3]
X is the account ID. For T54S/T48S/T48G/T46S/T46G/T29G, X=1-16; for T52S/T42G/T42S, X=1-12; for
T41P/T41S/T27P/T27G, X=1-6; for T40P/T40G/T23P/T23G, X=1-3; for T21(P) E2, X=1-2; for T19(P) E2, X=1.
Hotline
Hotline, sometimes referred to as hot dialing, is a point-to-point communication link in which a call is
automatically directed to the preset hotline number. If you lift the handset, press the Speakerphone key
or the line key, and do nothing for a specified time interval, the IP phone will automatically dial out the
hotline number. Yealink IP phones only support one hotline number.