Yealink T27G

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
356
3-3
...
31-31
If it is set to other values, the IP phone will receive the incoming multicast paging call
with a higher or equal priority and ignore the one with a lower priority when a voice
call is in progress.
Default
31
Web UI
Directory->Multicast IP->Paging Barge
Parameter
multicast.receive.ignore_dnd.priority
<y0000000000xx>.cfg
Description
It configures the lowest priority of the multicast paging call that can be received when
DND is activated in phone mode.
1 is the highest priority, 31 is the lowest priority.
Permitted
Values
0-Disabled, all incoming multicast paging calls will be automatically ignored when
DND is activated in phone mode.
1-1
2-2
3-3
...
31-31
If it is not set to 0 (Disabled), the IP phone will receive the incoming multicast paging
call with a higher or same priority than this value and ignore that with a lower priority
than this value when DND is activated in phone mode.
Default
0
Web UI
Directory->Multicast IP->Ignore DND
Parameter
multicast.listen_address.X.volume
[1]
<y0000000000xx>.cfg
Description
It configures the volume of the speaker when receiving the multicast paging calls.
If it is set to 0, the current volume of the speaker takes effect. The volume of the
speaker can be adjusted by pressing the Volume key in advance when the phone is
during a call. You can also adjust the volume of the speaker during the paging call.
If it is set to 1 to 15, the configured volume takes effect and the current volume of the
speaker will be ignored. You are not allowed to adjust the volume of the speaker
during the paging call.
Example:
multicast.listen_address.1.volume = 1
Permitted
Values
Integer from 0 to 15