Yealink T27G

Advanced Features
461
Values
Default
Blank
Parameter
blf.enhanced.idle.talking.action
<y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is
talking and monitored user is idle.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.idle.talking.action = newcall
Note: It works only if “blf.enhanced.idle.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
Permitted
Values
String
Default
Blank
Parameter
blf.enhanced.idle.idle.action
<y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor and
monitored user are idle.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.idle.idle.action = 1234$Tinvite$
Note: It works only if “blf.enhanced.idle.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
Permitted
Values
String
Default
Blank
BLF Key LED/Icon and Behavior for Call-in State Configuration
The following table lists the parameters you can use to configure BLF key LED/icon and Behavior for
call-in state (the monitored user is ringing).
Parameter
blf.enhanced.callin.enable
<y0000000000xx>.cfg
Description
It enables or disables the custom configuration when the monitored user is ringing.
Note: It is not applicable to T19(P) E2 IP phones.
Permitted
Values
0-Disabled
1-Enabled, the IP phone will display the custom BLF/BLF List DSS key LED status/icon
colors and perform the custom behavior when pressing the BLF/BLF List DSS key.
Default
0