Yealink VC800 - Page 179

Configuring System Settings
165
Parameter
Description
Configuration
Method
Default: Hour 24
Date Format/Date
Configures the date format.
 WWW MMM DD
 DD-MMM-YY
 YYYY-MM-DD
 DD/MM/YYYY
 MM/DD/YY
 DD MMM YYYY
 WWW DD MMM
Default: YYYY-MM-DD
Remote Control
Web User Interface
To configure the NTP server, time zone and DST via web user interface:
1. Click on Setting->Date& Time.
2. Select Disabled from the pull-down list of Manual Time.
3. Select the desired time zone from the pull-down list of Time Zone.
4. Enter the domain names or IP addresses in the Primary Server and Secondary Server
fields respectively.
5. Enter the desired time interval in the Synchronism (15~86400s) field.
6. Select the desired value from the pull-down list of Daylight Saving Time.
If you select Enabled, do one of the following:
- Mark the DST By Date radio box in the Fixed Type field.
Enter the start time in the Start Date field.