Yealink VC800 - Installing the VC800 Video Conferencing System

Administrator’s Guide for Yealink VC800 Video Conferencing System
26
Parameter
Description
Configuration Method
12. Host name is optional, so it is not
a mandatory configuration item. For
more information, contact your
network administrator.
If you change this parameter, the
system will reboot to make the
change take effect.
To configure DHCP via web user interface:
1. Click on Network->LAN Configuration.
2. In the IPv4 Config block, mark the DHCP radio box.
3. (Optional.) Enter the host name of the system in the Host Name field.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5. Click Confirm to reboot the system immediately.