Yealink VC800 - Page 41

Configuring Network
27
To configure DHCP via the remote control:
1. Select More->Setting->Advanced (default password: 0000)->Internet
Configuration->IPv4.
2. Check the DHCP checkbox.
3. Select Save and then press to accept the change.
The display device prompts “Reboot now?”.
4. Select OK and then press to reboot the system immediately.
Static DNS
Even though DHCP is enabled, you can manually configure the static DNS address(es).
Parameters of static DNS on the system are described below:
Parameter
Description
Configuration Method
Static DNS
Triggers the static DNS feature to on
or off.
Default: Off
Note: If it is set to Off, the system
will use the IPv4 DNS obtained from
DHCP.
If it is set to On, the system will use
manually configured static IPv4
DNS.
It only works if the value of the “IPv4
Config” is set to DHCP. If you
change this parameter, the system
will reboot to make the change take
effect.
Remote Control
Web User Interface
Primary DNS
Configures the primary IPv4 DNS
server.
Default: Blank
Note: It only works if the value of
the "Static IPv4 DNS" is set to On. If
you change this parameter, the
system will reboot to make the
change take effect.
Remote Control
Web User Interface
Secondary DNS
Configures the secondary IPv4 DNS
server.
Default: Blank
Note: It only works if the value of
Remote Control
Web User Interface