Configuring Network
31
2. Select desired value from the pull-down list of IPv4/IPv6.
3. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
4. Click OK to reboot the phone.
To configure a static IPv4 address via web user interface:
1. Click on Network->LAN Configuration.
2. In the IPv4 Config block, mark the Static IP radio box.
3. Enter the desired values in the IP Address, Subnet Mask, Gateway, Primary DNS and
Secondary DNS fields.
4. Click Confirm to accept the change.
To Next Page
Loading...
Need help?
General
