User Guide for the W56P IP DECT Phone
90
Why cannot the handset be registered to the base station?
If the network works normally, you can check the compatibility between base station
and handset. There are 2 sets of base stations, complied with the FCC and CE
standards respectively. You can check it from the back of the base station. There are
also 2 sets of handsets, American and Europe area respectively.
The American area handset is compatible with FCC standard base station.
The Europe area handset is compatible with CE standard base station.
Why can’t I receive calls?
Ensure that the DND mode is not activated. Refer to Do Not Disturb (DND) on page
73.
Ensure that Always Forward feature is not enabled. Refer to Call Forward on page
74.
Why do I hear some noise during a call?
Ensure that you are not using the handset or base station in an area with high
electrical interference. You can reposition the handset and the base station to keep
them far away from sources of high electrical interference.
Ensure that the handset is not too far from the base station.
Restart the base station and place a call to see if there is still noise heard during the
call.
Why does paging fail?
Check the current mode of the base station. If the base station is not in the paging
mode, press the paging key on the base station to enter the paging mode.
Ensure that there is at least one handset registered to the base station.
To Next Page
Loading...
