User Guide for the W56P IP DECT Phone
62
feature are available for selection:
On (Beep On): Auto intercom feature is on. The handset will answer an incoming
internal intercom call automatically and play a warning tone.
On (Beep Off): Auto intercom feature is on. The handset will answer an incoming
internal intercom call automatically without a warning tone.
Off: Auto intercom feature is off. You need to answer an incoming internal intercom
call by pressing the Accept soft key.
To configure auto intercom via the handset:
1. Press to enter the main menu.
2. Select Settings->Telephony->Auto Intercom.
The LCD screen displays three configuration types.
3. Press or to highlight the desired configuration type.
4. Press the Change soft key.
The radio box of the selected configuration type is marked.
In some instances, you may need to restart the base station to refresh the settings.
To restart the base station via the handset:
1. Press to enter the main menu.
2. Select Settings->System Settings->Base Restart.
3. Enter the system PIN (default: 0000), and then press the Done soft key.
After the above steps, the registration LED and network status LED go out simultaneously.
After a period of time, the LED indicators will illuminate solid green again when the base
station restarts successfully.
Base restart is also configurable via the web user interface at the path:
Settings->Upgrade.
To avoid unauthorized register or access to some features on the handset, you should
keep the base PIN secret. The default base PIN is “0000”, you can change the default
base PIN.
To change the base PIN via the handset:
1. Press to enter the main menu.
2. Select Settings->System Settings->Change Base PIN.
3. Enter the system PIN (default: 0000), and then press the Done soft key.