Phone Settings
35
To configure ring tones via the handset:
1. Press to enter the main menu.
2. Select Settings->Audio->Ring Tones->Melodies.
3. Press or to highlight the Intercom Call option or the desired line.
4. Press or to select and listen to the desired ring tone.
5. Press the Save soft key to accept the change or the Back soft key to cancel.
Advisory tones are acoustic signals of your handset, which inform you of different
actions and states. The following advisory tones can be configured independently of
each other:
Keypad Tone: plays when you press any key of the keypad.
Confirmation: plays when you save settings or places the handset in the charger
cradle.
Low Battery: plays when the capacity of the battery is low and the handset
requires charging.
To configure advisory tones via the handset:
1. Press to enter the main menu.
2. Select Settings->Audio->Advisory Tones.
3. Press or to select the desired value from the Keypad Tone field.
4. Press or to select the desired value from the Confirmation field.
5. Press or to select the desired value from the Low Battery field.
6. Press the Save soft key to accept the change or the Back soft key to cancel.
Note
Handset backlight status in the charging state or out of the charging state can be
configured independently of each other. If enabled, the backlight is always on.
Otherwise, the backlight is turned off after the handset is idle for a period of time. But
the backlight is automatically turned on when an incoming call arrives, a key is pressed
or the status of handset changes. You can disable the backlight to save power.
If the silent mode is active, the advisory tones will not play, but you can still see the low
battery and confirm information alert on the LCD screen. For more information on the
silent mode, refer to Switching Silent Mode to On/Off on page 30.
To Next Page
Loading...
