User Guide for the W56P IP DECT Phone
30
To lock the keypad via the handset:
1. Long press when the handset is idle until the LCD screen prompts “Keypad
Locked, Press and hold ‘#’ to unlock!”.
The keypad is locked and the icon appears on the status bar.
You can still answer or reject incoming calls as usual. You can also end the call by
pressing .
To unlock the keypad via the handset:
1. Long press again until the LCD screen prompts “Keypad Unlocked”.
The keypad is unlocked and the icon disappears from the idle screen.
Note
If the silent mode is switched to On, the handset will not ring when receiving an
incoming call, but you can still see the incoming call information on the LCD screen. You
can switch the silent mode to On if you do not want to be disturbed.
To switch the silent mode to On via the handset:
1. Long press until the LCD screen prompts “All Ring Tones Off”.
The silent mode is on. The icon appears on the status bar.
To switch the silent mode to Off via the handset:
1. Long press again until the LCD screen prompts “All Ring Tones On”.
The silent mode is off. The icon disappears from the status bar.
Note
You can locate a misplaced handset using the base station to which the handset is
registered.
To locate a handset via the handset:
1. Press on the base station.
All handsets registered to this base station will ring simultaneously (Paging) and
If the keypad is locked, only the emergency numbers can be dialed out. You must enter
the emergency number continuously and completely. To place emergency calls, you
should configure the emergency numbers in advance. For more information, refer to
Emergency Numbers on page 56.
When the silent mode is active, the advisory tones will not be played, regardless of their
settings.
To Next Page
Loading...
