User Guide for the W56P IP DECT Phone
54
To configure the delay time for dial-now rule via web user interface:
1. Click on Features->General Information.
2. Enter the time between 0 and 14 (seconds) in the Time-Out for Dial-Now Rule field.
The default value is “1”.
3. Click Confirm to accept the change.
Note
Area codes are also known as Numbering Plan Areas (NPAs). They usually indicate
geographical areas in a country. This feature is necessary only when dialing the number
outside the code area. For example, area code is configured as “Code: 011, Minimum
Length: 4, Maximum Length: 11”, then when you dial out the number “56789”, which has
digits between 4 and 11, the phone will add the area code before the number and dial
out (01156789).
To configure area code via web user interface via the handset:
1. Click on Settings->Dial Plan->Area Code.
2. Enter the desired value in the Code, Minimum Length (1-15) and Maximum Length
(1-15) field respectively.
Dial-now rule and delay time for dial-now rule is configurable via web user interface
only.
Dial-now rule is applicable for all the handset registered to the base station.
To Next Page
Loading...
