Yealink W56P - Page 66

User Guide for the W56P IP DECT Phone
52
4. Enter the desired line ID in the Account field or leave it blank.
5. Click Add to add the replace rule.
When you enter the number “1” using the keypad and then dial out using the
configured account, the handset will dial out “104” instead.
Note
To edit a replace rule via web user interface via the handset:
1. Click on Settings->Dial Plan->Replace Rule.
2. Select the desired replace rule by clicking the replace rule or checking the check
box.
3. Edit the value in the Prefix and Replace field respectively.
4. Enter the desired line ID in the Account field or leave it blank.
5. Click Edit to accept the change.
To delete one or more replace rules via web user interface via the handset:
1. Click on Settings ->Dial Plan->Replace Rule.
2. Select one or more replace rules by clicking the replace rule(s) or checking the
check box(es).
3. Click Delete to delete the replace rule(s).
Note
The valid value of the “Account” parameter can be one or more digits among 1, 2, 3, 4
and 5, each of which represents a line ID. Multiple digits must be separated by commas.
For example, when you enter the value “1, 2” in the Account field, this dial plan rule will
apply to account1 and account2.
If you leave the Account field blank or enter 0, this dial plan rule will apply to all
accounts.
Replace rule is configurable via web user interface only.
Replace rule is applicable for all the handset registered to the base station.