Yealink W56P - Page 92

User Guide for the W56P IP DECT Phone
78
4. Enter the conference URI (e.g., conference@example.com) in the Conference URI
field.
5. Click Confirm to accept the change.
Note
To set up a network conference call via the handset:
1. Place a call to the first party.
2. Press the Options soft key, and then select Conference.
3. Do one of the following:
- Enter the number of the second party or select the handset you want to add to
the conference.
Press , , or the Conf. soft key to dial out.
- Press the Directory soft key, and select the desired contact.
Press , , or the Call soft key.
If both the office number and the mobile number of the contact are stored,
select the desired number and press , , or the OK soft key to dial
out.
4. When the second party answers the call, you can consult with him or her before
adding the call to the conference.
5. Press the Conf. soft key again to join all parties in the conference.
To join two calls together into a conference call via the handset:
1. Place two calls on the handset.
2. Select the desired call and make sure the call is active.
Network Conference is only configurable via the web user interface.