MyPBX U100/U200 Administrator Guide
124/195
SPEEX:
Speex is an Open Source/Free Software patent-free audio compression
format designed for speech. The Speex Project aims to lower the barrier of entry
for voice applications by providing a free alternative to expensive proprietary
speech codecs. Moreover, Speex is well-adapted to Internet applications and
provides useful features that are not present in most other codecs.
G.726: A PSTN codec, used worldwide, that provides good voice quality and
consumes 32kbit/s in each direction (receiving and transmitting) of a VoIP call.
G.726 is supported by some VoIP phones.
ADPCM, G.729A, H261, H263, H263p, H264.
Note: If you would like to use G.729, please enter your license.
6.7.3 Blacklist
Blacklist is used to block an incoming/outgoing call. If the number of
incoming/outgoing call is registered in the number blacklist, the caller will hear
the following prompt: “The number you have dialed is not in service. Please
check the number and try again”. The system will then disconnect the call.
Figure 6-66
We can add a number with the type: inbound, outbound or both.
Figure 6-67
Note: Add a phone number in blacklist, such as “05921234567”:
1) If the type is “inbound”, then this number can’t be called.
2) If the type is “outbound”, then the extensions in MyPBX can’t call this
number.
To Next Page
Loading...
Need help?
General
