MyPBX U100/U200 Administrator Guide
15/195
Status
Ok: The ports connect correctly.
Disconnected: The port hasn’t connected to the BRI line
4.2 System Status
In this page, we can check the status of MyPBX system, including the hardware,
firmware version and the network status of LAN and WAN ports.
4.2.1 System Info
In this page, we can check the hardware/firmware version, or the disk usage of
MyPBX.
Figure 4-3
4.2.2 Network Status
In this page, the IP address of LAN and WAN port will appear. If OpenVPN is
configured well, they will be displayed here too.