Yeastar Technology MyPBX U100 Administrator's Guide

MyPBX U100/U200 Administrator Guide
19/195
Step8: Check the WAN’s Status (Status  Network status).
·PPPoE
If your DSL provider says that you are connecting through PPPoE or if you
normally enter a user name and password to access the Internet, perform these
steps:
Step1: Select PPPoE as the WAN Connection Type.
Step2: Enter the User Name.
Step3: Enter the Password.
Step4: Click the Save button to save the settings.
Step5: Reboot the device.
Step6: Check the WAN’s Status (Status  Network status)
5.1.3 DHCP Server
Dynamic Host Configuration Protocol (DHCP) is a network protocol that enables
a server to automatically assign an IP address to a computer from a defined
range of numbers (i.e., a scope) configured for a given network. You can set a
local network NTP server for MyPBX here too
Note: MyPBX U100&U200 can be working as a DHCP server, but cannot be
regarded as a router.
Figure 5-3
5.1.4 VLAN Settings
A VLAN (Virtual LAN) is a logical local area network (or LAN) that extends

Yeastar Technology MyPBX U100 Specifications

General

Brand	Yeastar Technology
Model	MyPBX U100
Category	Telephone Accessories
Language	English