Yeastar Technology MyPBX U100 Administrator's Guide

MyPBX U100/U200 Administrator Guide
43/195
Figure 5-35
5.5.5 Reset and Reboot
We can reset or reboot MyPBX U100&U200 via web directly in this page.
Figure 5-36
·Reboot System
Warning: Rebooting the system will terminate all active calls!
·Reset to Factory Defaults
Warning: A factory reset will erase all configuration data on the system.
Please do not turn off the system until the RUN light begins blinking. Any power
interruption during this time could cause damage to the system.
5.5.6 Hot Standby
Redundancy is achieved by using duplicate hardware and software installations
and synchronizing data and operating state. Redundancy assures smooth
operation even if a system goes down. Essentially a duplicate backup system
takes over with virtually no loss of service. This technique assures absolute
reliability no matter what failure occurs. In mission critical installations,
redundancy is a way to address possibility of any failure.
Note 1: Before enabling the Hot Standby feature, please make sure that the

Yeastar Technology MyPBX U100 Specifications

General

Brand	Yeastar Technology
Model	MyPBX U100
Category	Telephone Accessories
Language	English