Yeastar Technology MyPBX U100 Administrator's Guide

MyPBX U100/U200 Administrator Guide
125/195
6.7.4 Callback Settings
MyPBX allows caller A to dial an inbound route number, and after hearing the
ring, A can hang up the call or wait for MyPBX to cut off the call, then MyPBX will
call A with this number. When A picks up the call, A can dial the number he
wants to call; MyPBX will call the number with its outbound route.
Note:
1. If you’d like to use callback feature, please make sure it’s enabled on the
inbound route setting panel.
2. No callback rules needed to be set if the trunk supports call back with the
caller ID directly.
Figure 6-68
·Allow All Numbers
If you want to apply Callback function to all incoming numbers, please tick Allow
All numbers.
Follow the steps below to use this function.
Step 1: Enable Callback.
Inbound Routes – Choose “Yes” on” Enable Callback” to enable this function.
Figure 6-69

Yeastar Technology MyPBX U100 Specifications

General

Brand	Yeastar Technology
Model	MyPBX U100
Category	Telephone Accessories
Language	English