EasyManuals Logo

Yeastar Technology MyPBX U100 Administrator's Guide

Yeastar Technology MyPBX U100
195 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #152 background imageLoading...
Page #152 background image
MyPBX U100/U200 Administrator Guide
152/195
Figure D-4
Step4. Turn on the power and connect the network cable to IP Phone.
Remark: The factory default setting of DHCP for IP Phone is enabled, so you
can skip this step to step 5.
If the DHCP is disabled, please follow below step to enable it (e.g. Yealinks IP
Phone)
1. Log in IP phones web page.
2. Enable DHCP.
Figure D-5
Step5. Finish.

Table of Contents

Other manuals for Yeastar Technology MyPBX U100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yeastar Technology MyPBX U100 and is the answer not in the manual?

Yeastar Technology MyPBX U100 Specifications

General IconGeneral
BrandYeastar Technology
ModelMyPBX U100
CategoryTelephone Accessories
LanguageEnglish