YOKOGAWA CA71 HANDY CAL - Reading Data from Memory

IM CA71-E
6-5
Memory Functions
1
2
3
4
5
6
7
8
9
10
11
12
13
App
NOTE
To stop overwriting the data, press the key one time. This cancels
saving data, reverting to the original state of being able to save/read data
to/from memory.
TIP
To cancel the memory mode (saving/reading), press the key one more
time.
(Executing the MEM SAVE function automatically cancels the memory mode.)
6.2 Reading Data from Memory
Step 1: Press the
key once. The LCD shows MEM No. xx.
At this point, the MEM No. indicator shows a memory number
immediately following the one most recently used to save
data. (Memory is ready for data saving.)
Step 2: Pressing the
key causes the on-screen
indication to blink, indicating the calibrator is reading from
memory.
Step 3: Using the pair of
key, select the memory number
whose data you want to read. The LCD shows the data thus
read out of memory. The items of the read data are shown on
their respective measured-value and generated-value display
areas. If the area with the memory number contains no saved
data, the LCD shows - - - - -.
TIP
• To cancel reading from the memory mode, press the key or
the
key one more time.
• To save data anew while reading from memory, overwrite the existing
data by following step 2 in subsection 6.1.3, "Overwriting Data in Memory."
6.1 Saving Data into Memory