5-54
IM 710105-17E
Command Function Page
Common Command Group
*CAL? (CALibrate)
Executed calibration and queries the result. 5-291
*CLS (CLear Status)
Clears the standard event register, extended event register, and error queue. 5-291
*ESE (standard Event Status
Enable register)
Sets or queries the standard event enable register. 5-291
*ESR? (standard Event Status
Register)
Queries and clears the standard event register. 5-291
*IDN? (IDeNtify)
Queries the DLM2000 model. 5-291
*OPC (OPeration Complete)
Sets bit 0 (the OPC bit) of the standard event register to 1 upon the
completion of the specified overlap command.
5-291
*OPC? (OPeration Complete)
If you send *OPC?, the DLM2000 returns ASCII code 1 when the specified
overlap command is completed.
5-292
*OPT? (OPTion)
Queries the installed options. 5-292
*RST (ReSeT)
Resets the settings. 5-292
*SRE (Service Request Enable
register)
Sets or queries the service request enable register value. 5-292
*STB? (STatus Byte)
Queries the status byte register value. 5-292
*TST?
Performs a self-test and queries the result. The self-test consists of tests of
each kind of internal memory.
5-292
*WAI (WAIt)
Holds the subsequent command until the completion of the specified overlap
operation.
5-293
5.1 List of Commands
To Next Page
Loading...
