YOKOGAWA WT310EH - Page 37

2-10
IM WT310E-01EN
External Current Sensor Measurement Range in Menu
Configuration Mode
1.
When the /EX2 option is installed
(Display C)
5.
4.
Confirm the setting.
The unit is “mV.”
The unit is “V.”
5.
When the /EX1 option is installed
(Display C)
4.
Confirm the setting.
The unit is “V.”
3.
(Display C)
2.
The above options appear when the crest factor has been
set to 3. The following options appear when the crest factor
has been set to 6 or 6A.
Auto, E 5, E 2.5, E 1.25, dirECt
The above options appear when the crest factor has been
set to 3. The following options appear when the crest factor
has been set to 6 or 6A.
Auto, E 1, E 0.5, E 250, E 100, E 50, E 25, dirECt
The above menu is displayed on the WT332E/WT333E.
OntheWT310E,SEnSorappearsafterthe5mArange.
On the WT310EH, SEnSor appears after the 1 A range.
External Current Sensor Measurement Range in Quick
Configuration Mode
1.
Press CURRENT.
Inquickconfigurationmode,theCURRENTkeyandthe▼and▲keysilluminate.Nodisplayappearson
the menu.
2.4 Setting the Measurement Ranges When Using an External Current Sensor (Option)