3-1
IM WT310E-01EN
Holding Measured Values and Performing Single Measurements
3
3.1 Holding Measured Values
Procedure
Holding Measured Values
Press HOLD. The HOLD key illuminates, and the display of the measured values is held.
Releasing the Held State
Press HOLD when the measured values are being held. The hold key light will turn off and the display
will be updated.
Explanation
Hold
You can use the hold operation to stop measuring and displaying the measured data at each data
update interval and hold the display of all measurement function data. The D/A output, communication
output, and other values reflect the held values.
Note
Forinformationaboutholdingduringintegration,seesection5.1.
Chapter 3 Holding Measured Values and Performing Single Measurements
To Next Page
Loading...
Need help?
General
