Zeiss Axiovert 200 - START-UP

START-UP
Axiovert 200 Contents Carl Zeiss
B 40-080 e 03/01 2-1
START-UP
Contents
2 START-UP.......................................................................................................................2-5
2.1 Unpacking and installation of the microscope..................................................................2-5
2.2 Attachment of binocular (photo) tube..............................................................................2-6
2.2.1 Inserting the eyepieces and the centering telescope.........................................................2-6
2.2.2 Inserting the eyepiece reticle............................................................................................2-7
2.3 Attachment of transmitted-light illumination....................................................................2-8
2.3.1 Attachment of carrier for transmitted-light illumination (100 W).......................................2-8
2.3.2 Attachment of carrier for transmitted-light illumination (30 W).........................................2-8
2.4 Screw in objectives ..........................................................................................................2-9
2.5 Attachment of microscope stages..................................................................................2-10
2.5.1 Attachment of mechanical stage 130x85 R/L and mounting frame
for mechanical stage (K) ................................................................................................2-10
2.5.2 Attachment of scanning stage .......................................................................................2-10
2.5.3 Attachment of specimen stage 250x230, object guide and mounting frame
for object guide (M).......................................................................................................2-11
2.5.4 Attachment of heating stage .........................................................................................2-12
2.5.5 Attachment of gliding stage Z........................................................................................2-12
2.6 Attachment of condensers.............................................................................................2-13
2.6.1 Condensers for the Axiovert 200....................................................................................2-13
2.6.2 Condensers from the Axioplan 2 imaging / Axioskop 2 product line................................2-13
2.6.3 Changing the DIC prism in the condenser turret.............................................................2-14
2.7 Reflector turret..............................................................................................................2-15
2.7.1 Attachment of reflector turret........................................................................................2-15
2.7.2 Equipment of reflector turret .........................................................................................2-15
2.7.3 Changing the filter set in the FL reflector module...........................................................2-16
2.7.4 Changing the beam splitter in the FL reflector module....................................................2-16