Zeiss Axiovert 200 - Notes on instrument safety

INTRODUCTION
Axiovert 200 Notes on instrument safety Carl Zeiss
B 40-080 e 03/01 0-7
Notes on instrument safety
The Axiovert 200 / Axiovert 200 M microscopes were designed, produced and tested in compliance with
DIN 61010-1 (IEC 1010-1), Safety requirements for electrical measuring, control and laboratory
instruments, and meet the requirements of appendix I of directive 73/23/EC and the relevant CSA and UL
directives. The instruments meet the requirements of the EC directive 89/336/EC and the EMC legislation
of November 9th 1992. This operation manual includes information and warnings which must be
observed by the user.
The following warning and information symbols are used in this manual:
☞
NOTE
This symbol is a warning which you must observe under all circumstances.
CAUTION
This symbol is a warning which indicates a hazard to the instrument or instrument system.
CAUTION
This symbol is a warning which indicates a hazard to the user of the instrument.
CAUTION
Hot surface!
CAUTION
UV radiation is emitted!
CAUTION
Disconnect the instrument from the line before opening it!