OPERATION
Axiovert 200 Axiovert 200 M Carl Zeiss
B 40-080 e 03/01 3-17
Key to Fig. 3-13:
1 On / Off switch
2 Nosepiece (motorized)
3 Reflector turret (motorized)
4 OBJECTIVE keys (forward and backward)
5 REFLECTOR keys (forward and backward)
6 Focusing drive coarse / fine (motor-supported)
7 ZERO key
8 FOCUS keys (Work / Load)
9 HAL on / off key
10 FL key on / off (fluorescence shutter)
11 Toggle switch for illumination intensity and programming
12 1x OPTOVAR key (maximum of 3 positions)
13 Left / Right key for Sideport switching
14 Key for switching between visual observation, Frontport, Baseport
15 FCT key – programmable function key
16 Condenser (motorized)
17 LCD display
18 Key "Set LM"
19 RS 232 connector
20 CAN / SB connector (CAN-Bus, Sub-bus)
On / Off switch (3-13/1)
− position 0 = instrument switched off
− position I = instrument switched on, switch lights up
HAL key on/off (3-13/9)
− Brief pressing switches the halogen illuminator on or off alternately.
− When the unit is switched on again, the voltage present at the time of switching off is automatically
set again.
− When the unit is switched on, the lower line of the LCD display shows the voltage in a scale and the
lamp voltage value (nominal value). When the unit is switched off, the message HAL OFF appears on
the LCD display.
− Long pressing (> 1 s) automatically sets the brightness to 3200K for color photography.
Motorized focusing drive (3-13/6)
− Focusing knob available on both sides of the instrument.
− Coarse adjustment - big knob
− Fine adjustment - small knob
To Next Page
Loading...
